Lenox Locker Solid Plastic Technical Data
Lenox Locker - Solid Plastic
Tough, attractive, solid plastic never needs painting, resists dents and scratches
Impervious to moisture lockers will not rust or delaminate
Durab |
Bradley Lenox Locker Installation Instructions
Lenox Locker Installation instructions
Step 1: Optional Locker Base Installation
IMPORTANT: Make sure the base is square AND level before anchoring to the floor (the
base may be square but not |
Bradley Lenox Cubby Locker Technical data
Bradley Lenox Cubby Lockers
Tough, attractive, solid plastic never needs painting, resists dents and scratches
Impervious to moisture cubby will not rust or delaminate
D |
Bradley Lenox Locker Bench Technical Data
Bradley lenox Locker Bench Technical Data
Tough, attractive, solid plastic never needs painting, resists dents and scratches
Impervious to moisture lockers will not rust or d |
Bradley Lenox Locker Bench Installation
Bradley Lenox Locker Bench Installation ( With or without doors )
Pre-Installation Information
Tools Required
Tape measure, level and shims
Power Drill
Pop rivet gun |
Bradley Lenox Z Locker - Solid Plastic
Bradley Lenox Z Locker - Solid Plastic
Tough, attractive, solid plastic never needs painting, resists dents and scratches
Impervious to moisture lockers will not rust or delaminate
|
Bradley Solid Plastic Locker and Bench Colors
Lenox Lockers Color Selections
Gray (S200)
White (S201)*
Beige *** (S202)
Deep Blue (S203)
Black **** (S205)
|
Bradley Solid Plastic Bathroom Partition Colors
Bradley / Mills
Bradmar Partition Color Selections
Gray* (S200)
Burgundy (S211)
Beige *-*** (S202)
Deep Blue (S203) |
CSI Specification Guidelines Section 15400
Specifier notes are shown in italics and should be deleted from
the final document. Generally all of the manufacturers products in
this category are listed and the specifier must take care to dele |
Bradley Lenox Pedestal Bench Installation
Bradley Lenox Locker Pedestal Bench Installation
1. Position each pedestal on the underside of the bench. Mark the hole locations and remove the pedestals. Using a 3/16" drill bit, drill 1/2" deep |